Standard / sequential
A standard indicator illuminates as one signal. A sequential indicator lights in a timed sweep. The available mode is stated for each exact lamp.
Explore tail lights ↗LIGHTING GLOSSARY
The terms behind the lamp.
Signal modes, voltage, protection and installation requirements vary by model. Definitions are general; product pages remain the source for exact specifications.
Read the term here, then verify the exact value on the product and fitment records.
ULA
Unlock & Lock Action runs a lighting sequence when the compatible vehicle is locked or unlocked. It requires the specified option harness and is available only on listed models.
See HOMURA V500 ↗SEA
Starting & Ending Action runs a start-up or shut-down sequence. OIRAN identifies public-road restrictions for this mode, so the product instructions take priority.
Review V500 functions ↗ESS
Emergency Stop Signal support changes the warning pattern during hard braking or hazard operation on compatible systems. Support differs by lamp and variant.
Check fitment ↗Hyperflash
A vehicle may interpret the lower electrical load of an LED conversion as a failed bulb. The required resistor, controller or harness depends on the circuit.
View wiring & resistors ↗12 V / 24 V
Voltage is a product constraint. Match the lamp, resistor and harness to the vehicle system stated on the exact product page.
Browse all products ↗IP protection
An IP rating records resistance to dust and water under defined tests. It does not replace correct mounting, sealed connectors or installation.
See V500 protection ↗Approvals
Approval marks and road-use status are model- and market-specific. Confirm the part number, installation and local requirements before use.
Contact support ↗Confirm the complete installation.
Use the compatibility route to confirm the truck, lamp, resistor and harness together.
Check compatibility